产品中心
PRODUCT CENTER

  • 联系人 : 曹镜森先生
  • 联系电话 : 0769-82226193
  • 传真 : 0769-82226193
  • 移动电话 : 13925217478
  • 地址 : ** 广东省东莞市大朗镇仙村工业区
  • Email : caojingshen@126.com
  • 邮编 : 523792
  • 公司网址 : http://www.szdatian.net.cn
  • MSN : caoshingcer@126.com
  • QQ : 454992321
文章详情

假发丝专用恒温除湿干燥机 DDL-500 河南许昌

日期:2026-11-20 19:13
浏览次数:0
摘要:假发丝原料低温恒温干燥配低露点气流,减少泛黄、回潮与断丝。

假发丝专用恒温除湿干燥机 DDL-500 河南许昌

产品定位|Positioning

假发丝多为改性涤纶或尼龙单丝,比表面积大、回潮快,常规料斗干燥难以把水分压到纺丝要求。DDL-500 以低温长停留配合双塔除湿,把原料含水率稳定在纺丝窗口内,供许昌假发产业带的拉丝与后整理工序使用。

Wig fibre is mostly modified polyester or nylon monofilament with a large specific surface, so it picks up moisture quickly and ordinary hopper drying cannot push moisture down to spinning requirements. DDL-500 uses a long low-temperature residence together with twin-tower dehumidifying to hold the material inside the spinning window, serving the drawing and finishing steps of the Xuchang wig cluster.

温度与露点的配合|Temperature and dew point

改性涤纶在高温下易泛黄,干燥温度建议控制在80℃至100℃,靠延长停留时间而不是提高温度来脱水;干燥空气露点保持在-40℃以下,出机后物料温度与露点同步回落,避免出料瞬间吸潮。

Modified polyester yellows readily at high temperature, so drying is held at 80–100°C and dehydration comes from longer residence rather than more heat; drying air stays below -40°C dew point, and material temperature and dew point fall together at discharge so the fibre does not re-absorb moisture on exit.

结构说明|Construction

不锈钢料斗带保温夹层与视窗,内壁抛光减少挂料;机柜内双塔交替吸附再生,配露点显示与超温报警;出料口可接输送管路直连挤出机,减少敞口转运。

The stainless hopper has an insulated jacket and sight window with polished inner walls to reduce material hang-up; twin towers inside the cabinet alternate adsorption and regeneration with dew-point display and over-temperature alarm; the discharge can feed a conveying line straight to the extruder to cut open handling.

相关供货信息:假发丝原料深度除湿干燥机 DDL-300 河南许昌 假发丝原料除湿干燥系统 DDL-450 河南许昌 改性涤纶假发丝干燥机 DDL-200 河南许昌

粤公网安备 44190002002288号