产品中心
PRODUCT CENTER

  • 联系人 : 曹镜森先生
  • 联系电话 : 0769-82226193
  • 传真 : 0769-82226193
  • 移动电话 : 13925217478
  • 地址 : ** 广东省东莞市大朗镇仙村工业区
  • Email : caojingshen@126.com
  • 邮编 : 523792
  • 公司网址 : http://www.szdatian.net.cn
  • MSN : caoshingcer@126.com
  • QQ : 454992321
文章详情

模具除露机 潍坊 MD-80|Mold Dehumidifier / Anti-condensation Unit

日期:2026-11-21 02:40
浏览次数:5
摘要:潍坊塑料管材与农膜集群用模具除露机,露点 -18~-22 ℃,4 路送风。中英文对照说明防结露要点。

潍坊模具除露机 MD-80

潍坊模具除露机 MD-80|Mold Dehumidifier MD-80

面向潍坊的塑料管材与农膜集群。出风露点 -18~-22 ℃,处理风量按 80 kg 级模具区配置,可配 4 路出风分配,适合机边固定安装。

For the plastic pipe and agricultural film cluster in 潍坊: outlet dew point -18~-22 °C, airflow sized for a 80 kg class mould area, up to 4 outlet branches, suited to fixed machine-side mounting.

这一条重点讲:停机与夜班防锈

Focus of this page: After shutdown the mould does not warm back; ten minutes of dry air before the next shift cuts rust complaints

停机后模具不回温,次日开机前先吹干燥风十分钟,可明显减少锈蚀投诉。潍坊的车间在梅雨季与冬季开机阶段,这个问题更集中。

After shutdown the mould does not warm back; ten minutes of dry air before the next shift cuts rust complaints. Workshops in 潍坊 see this most often in the plum-rain season and at winter start-up.

结构与参数 / Structure and figures

转轮除湿 + 送风分配 + 过滤段;露点 -18~-22 ℃、出风温度可调 18~25 ℃、4 路独立风阀;机体带脚轮与吊装孔,管路建议保温。

Desiccant wheel, air distribution and filtration: dew point -18~-22 °C, outlet air 18-25 °C adjustable, 4 independent dampers; castors and lifting holes on the frame, ducting should be insulated.

与模温机联用时,先定模具温度再定送风露点,两者差值保持在 8 ℃ 以上更稳妥。

When used with a temperature controller, set the mould temperature first and the supply dew point second; keeping the gap above 8 °C is the safer choice.

交货与调试:潍坊及周边可上门安装,随机附送风管接头与操作说明。

Delivery: on-site installation in 潍坊 and nearby, with duct connectors and an operation manual included.

粤公网安备 44190002002288号