产品中心
PRODUCT CENTER

  • 联系人 : 曹镜森先生
  • 联系电话 : 0769-82226193
  • 传真 : 0769-82226193
  • 移动电话 : 13925217478
  • 地址 : ** 广东省东莞市大朗镇仙村工业区
  • Email : caojingshen@126.com
  • 邮编 : 523792
  • 公司网址 : http://www.szdatian.net.cn
  • MSN : caoshingcer@126.com
  • QQ : 454992321
文章详情

模具除露机 青岛 MD-50|Mold Dehumidifier / Anti-condensation Unit

日期:2026-11-21 06:47
浏览次数:10
摘要:青岛家电注塑与 PVC 管材集群用模具除露机,露点 -15~-20 ℃,3 路送风。中英文对照说明防结露要点。

青岛模具除露机 MD-50

青岛模具除露机 MD-50|Mold Dehumidifier MD-50

面向青岛的家电注塑与 PVC 管材集群。出风露点 -15~-20 ℃,处理风量按 50 kg 级模具区配置,可配 3 路出风分配,适合机边固定安装。

For the home-appliance injection and PVC pipe cluster in 青岛: outlet dew point -15~-20 °C, airflow sized for a 50 kg class mould area, up to 3 outlet branches, suited to fixed machine-side mounting.

这一条重点讲:送风分配与管路走向

Focus of this page: Outlet position matters more than airflow; feeding dry air to the lee side of the cavity often beats raising the volume

出风口位置比风量更影响效果,贴在型腔背风面送风往往比加大风量更有效。青岛的车间在梅雨季与冬季开机阶段,这个问题更集中。

Outlet position matters more than airflow; feeding dry air to the lee side of the cavity often beats raising the volume. Workshops in 青岛 see this most often in the plum-rain season and at winter start-up.

结构与参数 / Structure and figures

转轮除湿 + 送风分配 + 过滤段;露点 -15~-20 ℃、出风温度可调 18~25 ℃、3 路独立风阀;机体带脚轮与吊装孔,管路建议保温。

Desiccant wheel, air distribution and filtration: dew point -15~-20 °C, outlet air 18-25 °C adjustable, 3 independent dampers; castors and lifting holes on the frame, ducting should be insulated.

与模温机联用时,先定模具温度再定送风露点,两者差值保持在 8 ℃ 以上更稳妥。

When used with a temperature controller, set the mould temperature first and the supply dew point second; keeping the gap above 8 °C is the safer choice.

交货与调试:青岛及周边可上门安装,随机附送风管接头与操作说明。

Delivery: on-site installation in 青岛 and nearby, with duct connectors and an operation manual included.

粤公网安备 44190002002288号