产品中心
PRODUCT CENTER

  • 联系人 : 曹镜森先生
  • 联系电话 : 0769-82226193
  • 传真 : 0769-82226193
  • 移动电话 : 13925217478
  • 地址 : ** 广东省东莞市大朗镇仙村工业区
  • Email : caojingshen@126.com
  • 邮编 : 523792
  • 公司网址 : http://www.szdatian.net.cn
  • MSN : caoshingcer@126.com
  • QQ : 454992321
文章详情

塑料除湿干燥机 杭州 TCD-300|Plastic Desiccant Dryer / Dehumidifying Dryer

日期:2026-11-21 06:51
浏览次数:1
摘要:杭州包装与薄膜集群,露点 -20~-25 ℃,料斗 30 kg。中英文对照说明结构与参数。

杭州塑料除湿干燥机 TCD-300

杭州塑料除湿干燥机 TCD-300|Plastic Desiccant Dryer TCD-300

适用于杭州的包装与薄膜集群。设备按料斗容积 30 kg、风量约 50 m³/h、露点 -20~-25 ℃ 的配置供货,可配机边或集中两种安装方式。

Built for the packaging and film cluster in 杭州, supplied with a 30 kg hopper, about 50 m³/h airflow and a dew point of -20~-25 °C, for machine-side or central installation.

这一条重点讲:露点波动排查

Focus of this page: When the dew point never reaches the set value, check regeneration temperature and filter blockage before blaming the wheel

露点长期达不到设定值时,先查转轮再生温度与滤网堵塞,再怀疑转轮本身。在杭州一带的车间,风量与料斗容积要随机台吨位一起定。

When the dew point never reaches the set value, check regeneration temperature and filter blockage before blaming the wheel. In workshops like those in 杭州, the airflow and hopper figure is set together with the machine tonnage.

结构与参数 / Structure and figures

蜂巢转轮除湿 + 电加热料斗 + 闭环风路;露点 -20~-25 ℃、料斗 30 kg、风量 50 m³/h、再生加热 120~160 ℃ 可调;料温上限按原料牌号设定,一般不超过 120 ℃。

Honeycomb wheel dehumidifying, electrical hopper heating and a closed-loop air path: dew point -20~-25 °C, hopper 30 kg, airflow 50 m³/h, regeneration 120-160 °C adjustable, material temperature normally kept under 120 °C.

接口为单相/三相可选,控制面板带露点显示与超温报警,料位不足时自动提示补料。

Single or three-phase supply, dew-point readout and over-temperature alarm on the panel, with a low-level refill prompt.

交货与调试:杭州及周边可上门安装调试,随机提供中文/英文操作说明与常见故障对照表。

Delivery: installation and commissioning are available in 杭州 and nearby areas, with Chinese/English manuals and a fault cross-reference table.

粤公网安备 44190002002288号