产品中心
PRODUCT CENTER
- 联系人 : 曹镜森先生
- 联系电话 : 0769-82226193
- 传真 : 0769-82226193
- 移动电话 : 13925217478
- 地址 : ** 广东省东莞市大朗镇仙村工业区
- Email : caojingshen@126.com
- 邮编 : 523792
- 公司网址 : http://www.szdatian.net.cn
- MSN : caoshingcer@126.com
- QQ : 454992321
PET瓶胚注塑干燥系统 潍坊 PDS-800|PET Preform Injection Drying System
潍坊PET瓶胚注塑干燥系统 PDS-800|PET Preform Injection Drying System PDS-800
面向潍坊的塑料管材与农膜集群。系统含预结晶段、除湿干燥段与机边输送段,按 800 kg/h 级瓶胚产量配置,干燥露点 -45~-50 ℃。
For the plastic pipe and agricultural film cluster in 潍坊: pre-crystallising, desiccant drying and machine-side conveying in one system, sized for about 800 kg/h of preforms with a drying dew point of -45~-50 °C.
这一条重点讲:露点与停留时间
Focus of this page: A reached dew point is only the precondition; too short a residence time also produces rejects, so log both
露点达标只是前提,停留时间不足同样出不合格瓶胚,两者要同时记录。潍坊的瓶胚车间在换牌号与开停机阶段,这一段较容易出批量异常。
A reached dew point is only the precondition; too short a residence time also produces rejects, so log both. Preform shops in 潍坊 hit this hardest when changing grade and at start-up or shutdown.
三段工艺与参数 / Three stages and figures
预结晶 150~170 ℃、搅拌防粘连;干燥 160~170 ℃、露点 -45~-50 ℃、停留 4~6 小时;成品含水控制在 50 ppm 以内,输送段保温密封。
Pre-crystallising at 150-170 °C with agitation against blocking; drying at 160-170 °C, dew point -45~-50 °C, 4-6 h residence; finished moisture kept under 50 ppm, conveying line insulated and sealed.
系统带露点、料温、料位三路显示,异常时报警而不是直接停机,便于值班人员判断。
Dew point, material temperature and level are all displayed; faults raise an alarm instead of an immediate stop, so the operator can judge.
交货与调试:潍坊及周边可上门安装并带料试机,随机提供中英文工艺参数表。
Delivery: installation and trial runs with material are available in 潍坊 and nearby, with a bilingual process parameter sheet.
