产品中心
PRODUCT CENTER

  • 联系人 : 曹镜森先生
  • 联系电话 : 0769-82226193
  • 传真 : 0769-82226193
  • 移动电话 : 13925217478
  • 地址 : ** 广东省东莞市大朗镇仙村工业区
  • Email : caojingshen@126.com
  • 邮编 : 523792
  • 公司网址 : http://www.szdatian.net.cn
  • MSN : caoshingcer@126.com
  • QQ : 454992321
文章详情

模具除露机 烟台 MD-50|Mold Dehumidifier / Anti-condensation Unit

日期:2026-11-21 01:53
浏览次数:5
摘要:烟台汽车内饰件集群用模具除露机,露点 -15~-20 ℃,3 路送风。中英文对照说明防结露要点。

烟台模具除露机 MD-50

烟台模具除露机 MD-50|Mold Dehumidifier MD-50

面向烟台的汽车内饰件集群。出风露点 -15~-20 ℃,处理风量按 50 kg 级模具区配置,可配 3 路出风分配,适合机边固定安装。

For the automotive interior parts cluster in 烟台: outlet dew point -15~-20 °C, airflow sized for a 50 kg class mould area, up to 3 outlet branches, suited to fixed machine-side mounting.

这一条重点讲:小批量多品种车间

Focus of this page: Workshops with frequent mould changes suit a mobile unit; fixed ducting only adds purging time

换模频繁的车间适合移动式除露机,固定管路反而增加吹扫时间。烟台的车间在梅雨季与冬季开机阶段,这个问题更集中。

Workshops with frequent mould changes suit a mobile unit; fixed ducting only adds purging time. Workshops in 烟台 see this most often in the plum-rain season and at winter start-up.

结构与参数 / Structure and figures

转轮除湿 + 送风分配 + 过滤段;露点 -15~-20 ℃、出风温度可调 18~25 ℃、3 路独立风阀;机体带脚轮与吊装孔,管路建议保温。

Desiccant wheel, air distribution and filtration: dew point -15~-20 °C, outlet air 18-25 °C adjustable, 3 independent dampers; castors and lifting holes on the frame, ducting should be insulated.

与模温机联用时,先定模具温度再定送风露点,两者差值保持在 8 ℃ 以上更稳妥。

When used with a temperature controller, set the mould temperature first and the supply dew point second; keeping the gap above 8 °C is the safer choice.

交货与调试:烟台及周边可上门安装,随机附送风管接头与操作说明。

Delivery: on-site installation in 烟台 and nearby, with duct connectors and an operation manual included.

粤公网安备 44190002002288号