产品中心
PRODUCT CENTER
- 联系人 : 曹镜森先生
- 联系电话 : 0769-82226193
- 传真 : 0769-82226193
- 移动电话 : 13925217478
- 地址 : ** 广东省东莞市大朗镇仙村工业区
- Email : caojingshen@126.com
- 邮编 : 523792
- 公司网址 : http://www.szdatian.net.cn
- MSN : caoshingcer@126.com
- QQ : 454992321
塑料除湿干燥机 烟台 TCD-300|Plastic Desiccant Dryer / Dehumidifying Dryer
烟台塑料除湿干燥机 TCD-300|Plastic Desiccant Dryer TCD-300
适用于烟台的汽车内饰件集群。设备按料斗容积 30 kg、风量约 50 m³/h、露点 -20~-25 ℃ 的配置供货,可配机边或集中两种安装方式。
Built for the automotive interior parts cluster in 烟台, supplied with a 30 kg hopper, about 50 m³/h airflow and a dew point of -20~-25 °C, for machine-side or central installation.
这一条重点讲:机边与集中供料的取舍
Focus of this page: Machine-side drying suits frequent small batches, central drying suits stable large batches; mixing them lowers overall efficiency
机边除湿适合换料频繁的小批量,集中供料适合稳定的大批量,两者混用会拉低整体效率。在烟台一带的车间,风量与料斗容积要随机台吨位一起定。
Machine-side drying suits frequent small batches, central drying suits stable large batches; mixing them lowers overall efficiency. In workshops like those in 烟台, the airflow and hopper figure is set together with the machine tonnage.
结构与参数 / Structure and figures
蜂巢转轮除湿 + 电加热料斗 + 闭环风路;露点 -20~-25 ℃、料斗 30 kg、风量 50 m³/h、再生加热 120~160 ℃ 可调;料温上限按原料牌号设定,一般不超过 120 ℃。
Honeycomb wheel dehumidifying, electrical hopper heating and a closed-loop air path: dew point -20~-25 °C, hopper 30 kg, airflow 50 m³/h, regeneration 120-160 °C adjustable, material temperature normally kept under 120 °C.
接口为单相/三相可选,控制面板带露点显示与超温报警,料位不足时自动提示补料。
Single or three-phase supply, dew-point readout and over-temperature alarm on the panel, with a low-level refill prompt.
交货与调试:烟台及周边可上门安装调试,随机提供中文/英文操作说明与常见故障对照表。
Delivery: installation and commissioning are available in 烟台 and nearby areas, with Chinese/English manuals and a fault cross-reference table.
