塑料破碎机维护与保养Plastic crusher maintenance and repair
塑料破碎机维护与保养
塑料破碎机维护与保养1、定期检查塑料破碎机皮带是否松弛，及时调紧。
塑料破碎机维护与保养2、**次启动前，应先**机室所剩余的碎料，减少启动阻力。应定期打开惯性罩和皮带轮罩，**法兰盘下方出灰口，因塑料破碎机室排出粉料进入转轴轴承。
塑料破碎机维护与保养3、更换刀具时，动刀与定刀之间的间隙:20HP以上破碎机0.8MM为佳，20HP以下的破碎机0.5MM为佳。回收料越薄，间隙可适当调大。
4、为保证刀具切口的锋利度，应常检查刀具，保证其锋利度，减少由于刀锋钝缺而引起其它部件的不必要损坏。
5、应把塑料破碎机安置通风位置，保证电机工作热量散发，延长其寿命。
6、定期检查刀具螺丝，全新塑料破碎机使用1小时后，用工具紧固动刀，定刀的螺丝，加强刀片与刀架间的固定性。
7、机器应保持良好接地。
8、应定期对轴承加注润滑油，保证轴承间的润滑性。
Plastic crusher maintenance and repair
Plastic crusher maintenance and maintenance 1, regular inspection of plastic crusher belt is loose, timely tightening.
Plastic crusher maintenance and maintenance 2, the second start, you should first clear the remaining pieces of the machine room to reduce the starting resistance. Should always open the inertia hood and pulley cover, remove the flange below the gray mouth, because the plastic crusher room discharge powder into the shaft bearings.
Plastic crusher maintenance and maintenance 3, the replacement of the tool, the knife and the knife between the gap: 20HP crusher 0.8MM better, 20HP below the crusher 0.5MM is better. The thinner the recovered material, the gap can be properly adjusted.
4, in order to ensure the sharpness of the cutter incision, should always check the tool to ensure its sharpness, reduce the blade blunt caused by other parts of the unnecessary damage.
5, the plastic crusher should be placed ventilation position to ensure that the motor heat dissipation, to extend its life.
6, regularly check the tool screw, the new plastic crusher use 1 hour later, with a tool to tighten the knife, set the screw, to strengthen the blade and the fixed between the knife.
7, the machine should be kept well grounded.
8, should be regularly filling the bearing lubricating oil to ensure the lubrication between the bearings.
