产品中心
PRODUCT CENTER
- 联系人 : 曹镜森先生
- 联系电话 : 0769-82226193
- 传真 : 0769-82226193
- 移动电话 : 13925217478
- 地址 : ** 广东省东莞市大朗镇仙村工业区
- Email : caojingshen@126.com
- 邮编 : 523792
- 公司网址 : http://www.szdatian.net.cn
- MSN : caoshingcer@126.com
- QQ : 454992321
文章详情
尼龙66纺丝除湿干燥机 DDL-600 浙江绍兴
日期:2026-11-20 19:14
浏览次数:0
摘要:尼龙66切片纺丝前深度除湿,高吸湿材料专用,出料含水率可控。
产品定位|Positioning
尼龙66吸湿性强,切片在空气中放置短时间即可吸收可观水分,纺丝前若含水率偏高,容易出现气泡丝与断头。DDL-600 以深度除湿配合低温干燥,把切片含水率压到纺丝要求的区间。
Nylon 66 is strongly hygroscopic and picks up noticeable moisture even on short exposure to air; if residual moisture is high before spinning, bubble filaments and broken ends follow. DDL-600 combines deep dehumidifying with low-temperature drying to bring chips into the spinning window.
工艺配合|Process fit
干燥温度建议控制在100℃至120℃区间,避免长时间高温导致切片氧化变色;干燥空气露点保持在-40℃以下,出料口与纺丝料斗之间采用密闭输送,减少二次吸潮。
Drying is held between 100°C and 120°C to avoid long high-temperature exposure that oxidises and discolours the chips; drying air stays below -40°C dew point and the path from discharge to the spinning hopper is closed to limit re-absorption.
