产品中心
PRODUCT CENTER

  • 联系人 : 曹镜森先生
  • 联系电话 : 0769-82226193
  • 传真 : 0769-82226193
  • 移动电话 : 13925217478
  • 地址 : ** 广东省东莞市大朗镇仙村工业区
  • Email : caojingshen@126.com
  • 邮编 : 523792
  • 公司网址 : http://www.szdatian.net.cn
  • MSN : caoshingcer@126.com
  • QQ : 454992321
文章详情

PET长丝纺丝深度除湿干燥系统 TPD-1000 江苏吴江

日期:2026-11-20 19:14
浏览次数:0
摘要:PET长丝纺丝前段切片结晶与深度除湿,出料含水率稳定,适配连续纺丝产线。

PET长丝纺丝深度除湿干燥系统 TPD-1000 江苏吴江

产品定位|Positioning

本系统用于PET切片在长丝纺丝前的结晶与深度除湿干燥。出料切片含水率控制在30ppm以内,干燥空气露点稳定在-40℃至-60℃区间,适合吴江、盛泽一带连续纺丝的长时间开机工况。

This system covers crystallization plus deep dehumidifying drying of PET chips ahead of filament spinning. Residual moisture stays below 30 ppm and drying-air dew point between -40°C and -60°C, suiting the long continuous runs typical of the Wujiang and Shengze spinning clusters.

结构与运行|Construction and operation

设备由结晶段、除湿段与输送段三部分组成。结晶段以热风循环完成切片预结晶,防止高温下结块;除湿段采用双塔交替吸附与再生,一塔送风、一塔再生,切换阀按时序动作,送风露点不因再生而抬升。

The unit combines a crystallization section, a dehumidifying section and a conveying section. Hot-air circulation pre-crystallizes the chips so they will not cake at high temperature; the dehumidifying section runs two desiccant towers alternately, one supplying dry air while the other regenerates, with sequence valves timed so the supply dew point does not lift during regeneration.

选型要点|Selection notes

按每小时切片处理量与纺丝位数量确定机型;长丝细旦、单丝纤度低的产线对露点更敏感,建议配置在线露点记录与含水率抽检接口。TPD系列提供400至2000公斤每小时的处理区间。

Model choice follows hourly chip throughput and the number of spinning positions. Fine-denier lines are more sensitive to dew point, so an on-line dew-point log and a moisture sampling port are recommended. The TPD range covers 400 to 2000 kg per hour.

相关供货信息:PET拉丝深度除湿干燥机 TPD-800 广东东莞 纺丝结晶除湿干燥系统 TPD-1200 浙江绍兴 PET短纤拉丝结晶干燥线 TPD-1500 江苏江阴

粤公网安备 44190002002288号