产品中心
PRODUCT CENTER
- 联系人 : 曹镜森先生
- 联系电话 : 0769-82226193
- 传真 : 0769-82226193
- 移动电话 : 13925217478
- 地址 : ** 广东省东莞市大朗镇仙村工业区
- Email : caojingshen@126.com
- 邮编 : 523792
- 公司网址 : http://www.szdatian.net.cn
- MSN : caoshingcer@126.com
- QQ : 454992321
模具除露机 东莞 MD-30|Mold Dehumidifier / Anti-condensation Unit
东莞模具除露机 MD-30|Mold Dehumidifier MD-30
面向东莞的3C 精密注塑集群。出风露点 -15~-20 ℃,处理风量按 30 kg 级模具区配置,可配 2 路出风分配,适合机边固定安装。
For the 3C precision injection cluster in 东莞: outlet dew point -15~-20 °C, airflow sized for a 30 kg class mould area, up to 2 outlet branches, suited to fixed machine-side mounting.
这一条重点讲:停机与夜班防锈
Focus of this page: After shutdown the mould does not warm back; ten minutes of dry air before the next shift cuts rust complaints
停机后模具不回温,次日开机前先吹干燥风十分钟,可明显减少锈蚀投诉。东莞的车间在梅雨季与冬季开机阶段,这个问题更集中。
After shutdown the mould does not warm back; ten minutes of dry air before the next shift cuts rust complaints. Workshops in 东莞 see this most often in the plum-rain season and at winter start-up.
结构与参数 / Structure and figures
转轮除湿 + 送风分配 + 过滤段;露点 -15~-20 ℃、出风温度可调 18~25 ℃、2 路独立风阀;机体带脚轮与吊装孔,管路建议保温。
Desiccant wheel, air distribution and filtration: dew point -15~-20 °C, outlet air 18-25 °C adjustable, 2 independent dampers; castors and lifting holes on the frame, ducting should be insulated.
与模温机联用时,先定模具温度再定送风露点,两者差值保持在 8 ℃ 以上更稳妥。
When used with a temperature controller, set the mould temperature first and the supply dew point second; keeping the gap above 8 °C is the safer choice.
交货与调试:东莞及周边可上门安装,随机附送风管接头与操作说明。
Delivery: on-site installation in 东莞 and nearby, with duct connectors and an operation manual included.
