产品中心
PRODUCT CENTER

  • 联系人 : 曹镜森先生
  • 联系电话 : 0769-82226193
  • 传真 : 0769-82226193
  • 移动电话 : 13925217478
  • 地址 : ** 广东省东莞市大朗镇仙村工业区
  • Email : caojingshen@126.com
  • 邮编 : 523792
  • 公司网址 : http://www.szdatian.net.cn
  • MSN : caoshingcer@126.com
  • QQ : 454992321
文章详情

模具除露机 苏州 MD-50|Mold Dehumidifier / Anti-condensation Unit

日期:2026-11-19 10:55
浏览次数:0
摘要:苏州片材、薄膜与医疗耗材集群用模具除露机,露点 -15~-20 ℃,3 路送风。中英文对照说明防结露要点。

苏州模具除露机 MD-50

苏州模具除露机 MD-50|Mold Dehumidifier MD-50

面向苏州的片材、薄膜与医疗耗材集群。出风露点 -15~-20 ℃,处理风量按 50 kg 级模具区配置,可配 3 路出风分配,适合机边固定安装。

For the sheet, film and medical consumable cluster in 苏州: outlet dew point -15~-20 °C, airflow sized for a 50 kg class mould area, up to 3 outlet branches, suited to fixed machine-side mounting.

这一条重点讲:模具温差与结露机理

Focus of this page: When the mould surface sits below the workshop dew point, moisture condenses on cavity and slider, leaving water marks and rust

模具表面温度低于车间露点时,水汽在型腔与滑块上凝结,脱模后出现水痕与锈斑。苏州的车间在梅雨季与冬季开机阶段,这个问题更集中。

When the mould surface sits below the workshop dew point, moisture condenses on cavity and slider, leaving water marks and rust. Workshops in 苏州 see this most often in the plum-rain season and at winter start-up.

结构与参数 / Structure and figures

转轮除湿 + 送风分配 + 过滤段;露点 -15~-20 ℃、出风温度可调 18~25 ℃、3 路独立风阀;机体带脚轮与吊装孔,管路建议保温。

Desiccant wheel, air distribution and filtration: dew point -15~-20 °C, outlet air 18-25 °C adjustable, 3 independent dampers; castors and lifting holes on the frame, ducting should be insulated.

与模温机联用时,先定模具温度再定送风露点,两者差值保持在 8 ℃ 以上更稳妥。

When used with a temperature controller, set the mould temperature first and the supply dew point second; keeping the gap above 8 °C is the safer choice.

交货与调试:苏州及周边可上门安装,随机附送风管接头与操作说明。

Delivery: on-site installation in 苏州 and nearby, with duct connectors and an operation manual included.

粤公网安备 44190002002288号