产品中心
PRODUCT CENTER
- 联系人 : 曹镜森先生
- 联系电话 : 0769-82226193
- 传真 : 0769-82226193
- 移动电话 : 13925217478
- 地址 : ** 广东省东莞市大朗镇仙村工业区
- Email : caojingshen@126.com
- 邮编 : 523792
- 公司网址 : http://www.szdatian.net.cn
- MSN : caoshingcer@126.com
- QQ : 454992321
双螺杆喂料器失重式计量混合系统
技术要点 / Technical Points
双螺杆喂料器配失重式计量适合粉料和难流动物料。双螺杆的自清洁能力和强制输送能力比单螺杆强,能处理易架桥的粉料和含填料的混合料。要点有三:双螺杆的啮合间隙要小,否则回漏影响精度;螺杆转速与补料频率要协调;粉料要在料斗加搅拌或破拱,防止架桥断料。

A twin-screw feeder with loss-in-weight metering suits powders and poorly flowing materials. Twin screws self-clean and force-feed better than a single screw, handling bridging powders and filled compounds. Three points matter: keep the intermeshing clearance small to limit slip and accuracy loss; coordinate screw speed with refill frequency; and agitate or break arches in the hopper to prevent starvation.
称重混料的计量原理 / Weighing and Blending Principle
精度指标看单次称重的重复性,常规机型在正负 0.3% 到 0.5%。影响精度的三个因素:称重传感器量程与配方比例不匹配(小比例组分用大量程传感器,误差占比大)、计量螺杆下料脉动、称重斗余料未清零。小比例色母(1% 以下)建议用独立小量程色母机。
Accuracy is the repeatability of a single weigh, typically plus or minus 0.3 to 0.5 percent. Three factors affect it: a load cell range mismatched to the recipe ratio, where a small component weighed on a large-range cell carries a big relative error; screw feed pulsation; and residual material in the weigh hopper not tared. For masterbatch below 1 percent, use a separate small-range doser.
称重式混料机按配方逐组分称重后混合,不是按体积比例。每个组分经各自的计量螺杆落到称重斗,称到设定值后停止,全部称完后开混合阀进入搅拌腔。分组称重的好处是换配方只需改设定值,不受物料比重变化影响;体积式混料机在比重变化时会直接偏料。
A gravimetric blender weighs each component by recipe rather than proportioning by volume. Each component is fed by its own metering screw into the weigh hopper and stops at setpoint; after all components are weighed, the mix valve opens into the blending chamber. Weighing each component means a recipe change is only a setpoint change and bulk density variation does not shift the ratio, unlike volumetric blenders.
